Powerhead - BRP E200HSLSEA Service Manual

POWERHEAD

TAPER PIN TOOL
TAPER PIN TOOL
COMPRESSION TESTING
Start and run outboard until it achieves operating
temperature, then shut OFF.
Disconnect crankshaft position sensor (CPS) con-
nector. Remove all spark plugs.
Advance throttle linkage to WOT.
Install compression tester's hose attachment into
spark plug hole (14 mm threads).
While cranking outboard with starter, note maxi-
mum pressure reading on gauge. Repeat proce-
dure for each cylinder.
220
– Hole for Storage
Scale: FULL SIZE
If engine shows a variation greater than 15 psi
(100 kPa) between cylinders, check for:
damaged cylinder head
•
damaged pistons
•
broken or stuck piston rings
•
scored cylinder walls
•
Return throttle to idle position and reconnect CPS
connector. Replace spark plugs. Refer to Spark
Plug Indexing on p. 84.