Cylinder Head Installation - BRP E200HSLSEA Service Manual

POWERHEAD
POWERHEAD ASSEMBLY
in each wrist pin hole. Gap of retaining ring faces
away from notch in piston.
1. Gap in retaining ring
2. Notch in piston
Installing Pistons
When all pistons and connecting rods are assem-
bled, install piston ring sets. Be sure rings are
installed in the cylinder used to test ring end gap.
Refer to POWERHEAD INSPECTION on p. 230.
Be sure gap of ring fits squarely
IMPORTANT:
around dowel pin.
236
IMPORTANT:
all Gel-Seal II has been removed from the cylinder
block and crankcase mating flanges. If traces of
hardened Gel-Seal II are left, main bearings could
be misaligned. Refer to CYLINDER BLOCK
CLEANING on p. 229.
Coat pistons, rings, cylinder walls, and ring com-
pressor with outboard lubricant.
Center connecting rod in piston and locate piston
rings on dowel pins. Place appropriate ring com-
pressor on piston.
Slide piston and rod assembly into the correct cyl-
DR1641
inder, as marked during disassembly. Guide con-
necting rod through cylinder block to avoid
scratching cylinder wall.
2
1
000756

Cylinder Head Installation

Lightly coat both sides of a new cylinder head
gasket with Gasket Sealing Compound. Place
gasket on cylinder block following instructions
printed on gasket.
Apply soapy water to water dam and insert into
block.
1
002048
1. Water dam
Before continuing, make sure that
49435
006965