Ignition Coil Installation - BRP E200HSLSEA Service Manual

ELECTRICAL AND IGNITION
IGNITION COIL SERVICING
IGNITION COIL
SERVICING
Ignition Coil Removal
Remove spark plug lead from ignition coil.
Remove two ignition coil retaining screws.
Do not lose the rubber washers between coil and
bracket.
Disconnect ignition coil electrical connector.
1
1. Screws
2. Connector
Ignition Coil Bracket Removal
Remove all ignition coils from bracket.
Remove spark plug lead ground screw.
1
1. Ground screw
150
Remove four screws and bracket.
1. Screws
2
Ignition Coil Bracket Installation
Install bracket with four screws. Tighten screws to
a torque of 60 to 84 in. lb. (7 to 9.5 N·m).
Install spark plug leads with ground screw.
Tighten screw securely.

Ignition Coil Installation

Connect ignition coil electrical connector. Place
electrical connector on its retainer.
007204
Install one rubber washer on each screw. Install
screw through ignition coil.
Install remaining rubber washers on screws
between coil and bracket.
2
1. Electrical connector
007205
2. Rubber washers
Install coil with washers on bracket.
Tighten screws to a torque of 60 to 84 in. lb. (7 to
9.5 N·m).
Install spark plug lead on ignition coil.
1
007206
1
007207