Table of Contents
Advertisement
Chapter 6 Wireless
Note: The Device applies the security settings of the SSID1 profile (see
page
mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 37 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 24 Network Setting > Wireless > WPS
LABEL
WPS
WPS 2.0
Method 1
Connect
Method 2
Register
80
66). If you want to use the WPS feature, make sure you have set the security
DESCRIPTION
Select Enable to activate WPS on the Device.
Select Enable to have the device use WPS 2.0 or Disable to have it use WPS 1.0.
Use this section to set up a WPS wireless network using Push Button Configuration (PBC).
Click this button to add another WPS-enabled wireless device (within wireless range of the
Device) to your wireless network. This button may either be a physical button on the
outside of device, or a menu button similar to the Connect button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of pressing
this button.
Use this section to set up a WPS wireless network by entering the PIN of the client into the
Device.
Enter the PIN of the device that you are setting up a WPS connection with and click
Register to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device's
settings.
Note: You must also activate WPS on that device within two minutes to have it present its
PIN to the Device.
Section 6.2 on
VMG1312-B10C User's Guide
Advertisement
Table of Contents
