ZyXEL Communications VMG1312-B10C User Manual page 71

Table 17 Wireless > General: Basic (WEP) (continued)
LABEL
Password 1~4
more.../less
WEP Encryption
6.2.3 Basic (802.1X)
Use this screen to configure 802.1X encryption and authentication. Configure your RADIUS server
information and WEP encryption settings. Use this security method if your wireless usernames and
passwords are configured on a RADIUS server.
In order to configure and enable WEP encryption, click Network Setting > Wireless to display the
General screen, then select Basic as the security level and 802.1X as the Security Mode.
Figure 31 Wireless > General: Basic (802.1X)
VMG1312-B10C User's Guide
DESCRIPTION
The password (WEP keys) are used to encrypt data. Both the Device and the wireless
stations must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one password, only one password can be activated at any one
time.
Click more... to show more fields in this section. Click less to hide them.
Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
Chapter 6 Wireless
71