ZyXEL Communications VMG1312-B10C User Manual page 69

Table 15 Network Setting > Wireless > General (continued)
LABEL
Enhanced
Multicast
Forwarding
Maximum
Upstream
Bandwidth
Maximum
Downstream
Bandwidth
BSSID
Security Level
Security Mode
Apply
Cancel
6.2.1 No Security
Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
Note: If you do not enable any wireless security on your Device, your network is
accessible to any wireless networking device that is within range.
Figure 29 Wireless > General: No Security
The following table describes the labels in this screen.
Table 16 Wireless > General: No Security
LABEL
Security Level
VMG1312-B10C User's Guide
DESCRIPTION
Select this check box to allow the Device to convert wireless multicast traffic into wireless
unicast traffic.
Specify the maximum rate for upstream wireless traffic to the WAN from this WLAN in
kilobits per second (Kbps).
Specify the maximum rate for downstream wireless traffic to this WLAN from the WAN in
kilobits per second (Kbps).
This shows the MAC address of the wireless interface on the Device when wireless LAN is
enabled.
Select Basic (WEP, 802.1X) or More Secure (WPA(2)-PSK, WPA(2)) to add security
on this wireless network. The wireless clients which want to associate to this network must
have same wireless security settings as the Device. When you select to use a security,
additional options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See the following sections for more details about this field.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
DESCRIPTION
Choose No Security to allow all wireless connections without data encryption or
authentication.
Chapter 6 Wireless
69