Table of Contents
Advertisement
8.3.1 Add/Edit Policy Forwarding
Click Add new Policy Forward Rule in the Policy Forwarding screen or click the Edit icon next
to a policy. Use this screen to configure the required information for a policy route.
Figure 63 Policy Forwarding: Add/Edit
The following table describes the labels in this screen.
Table 41 Policy Forwarding: Add/Edit
LABEL
Policy Name
Source IP
Source Subnet
Mask
Protocol
Source Port
Source MAC
WAN
Apply
Cancel
8.4 RIP
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
VMG1312-B10C User's Guide
DESCRIPTION
Enter a descriptive name of up to 8 printable English keyboard characters, not including
spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Chapter 8 Routing
129
Advertisement
Table of Contents
