Table of Contents
Advertisement
10.4.1 Add/Edit Port Triggering Rule
This screen lets you create new port triggering rules. Click Add new rule in the Port Triggering
screen or click a rule's Edit icon to open the following screen.
Figure 80 Port Triggering: Add/Edit
The following table describes the labels in this screen.
Table 58 Port Triggering: Configuration Add/Edit
LABEL
Active
Service Name
WAN Interface
Trigger Start
Port
Trigger End
Port
Trigger Protocol
Open Start Port
Open End Port
Open Protocol
OK
Cancel
VMG1312-B10C User's Guide
DESCRIPTION
Select the check box to enable this rule.
Enter a name to identify this rule using keyboard characters (A-Z, a-z, 1-2 and so on).
Select a WAN interface for which you want to configure port triggering rules.
The trigger port is a port (or a range of ports) that causes (or triggers) the Device to record
the IP address of the LAN computer that sent the traffic to a server on the WAN.
Type a port number or the starting port number in a range of port numbers.
Type a port number or the ending port number in a range of port numbers.
Select the transport layer protocol from TCP, UDP, or TCP/UDP.
The open port is a port (or a range of ports) that a server on the WAN uses when it sends
out a particular service. The Device forwards the traffic with this port (or range of ports) to
the client computer on the LAN that requested the service.
Type a port number or the starting port number in a range of port numbers.
Type a port number or the ending port number in a range of port numbers.
Select the transport layer protocol from TCP, UDP, or TCP/UDP.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
Chapter 10 Network Address Translation (NAT)
157
Advertisement
Table of Contents
