Printer Self-Test - Printek FormsMaster 8000 Operator's Manual

PRINTER SELF-TEST

The printer performs many self diagnostics each time power is turned on. If
you wish to perform an actual printing test, use the following steps.
1. Make sure the printer is powered on with ribbon and paper loaded.
2. Take the printer off line (the ONLINE indicator will be flashing red).
3. Press the SETUP/MENU button four times to display
the front panel.
4. Press either of the ITEM buttons until
top line.
5. Press either of the VALUE buttons until
the bottom line.
6. Press the ONLINE button.
7. The printer will now exit Setup and begin printing a rotating
character pattern. To stop or restart printing the test pattern, press the
ONLINE button.
8. To take the printer out of the test mode, stop the test by pressing the
ONLINE button.
9. Press the SETUP/MENU button four times to display
10.Press either of the ITEM buttons until
top line.
11.Press either of the VALUE buttons until
line.
12.Press the ONLINE button.
G E T T I N G S T A R T E D
TEST MENU
is displayed on the
Test Mode
is displayed on
Barber Pole
TEST MENU
is displayed on the
Test Mode
is displayed on the bottom
Off
on
.
17