Printek FormsMaster 8000 Operator's Manual page 34

D A I L Y O P E R A T I O N
7. If the new form is a different width than the previous form, unlock the
right tractor and move it to approximately the new position. Note
that the left tractor position is fixed and may not be moved.
8. Place the left edge of the new form in the left tractor with the holes
aligned with tractor pins. Make sure that the top edge of the form
does not extend above the top of the tractors.
9. Close the left tractor door.
10.Now position the paper in the right tractor in the same fashion. If
necessary, the position of the right tractor may be adjusted. To do
so, move the lever on the side of the tractor down to unlock the
tractor and slide the tractor sideways on the shafts. If necessary, the
paper guides between the tractors may be slid in either direction to
accommodate the form width. Make sure that the guides are spaced
evenly between the tractors.
After the paper is placed in the tractor and the door is closed, position
the tractor far enough to the right so that there is no buckle in the
paper between the tractors, but not so tight that the holes in the paper
are distorted. Lock the tractor in place by returning the lever to the
up position.
28
Paper positioned in left tractor.