Printer Self-Test - Printek FORMSMASTER 8000SE Operator's Manual

Selecting Which Form to Print
11. Close the paper door.
12. Press the FORM SELECT button until the desired form is displayed
and then press the LOAD button. The printer will now move the
selected form into position for printing.
13. Place the printer on line by pressing the ONLINE button.

Printer Self-Test

The printer performs many self diagnostics each time power is turned on. If
you wish to perform an actual printing test, use the following steps.
1. Make sure the printer is powered on with ribbon and paper loaded.
2. Take the printer off line (the ONLINE indicator will be flashing red).
3. Press the SETUP/MENU button four times to display TEST MENU
on the front panel.
4. Press either of the ITEM buttons until
top line.
5. Press either of the VALUE buttons until
the bottom line.
6. Press the ONLINE button.
7. The printer will now exit Setup and begin printing a rotating character
pattern. To stop or restart printing the test pattern, press the ONLINE
button.
8. To take the printer out of the test mode, stop the test by pressing the
ONLINE button.
9. Press the SETUP/MENU button four times to display
10. Press either of the ITEM buttons until
top line.
G E T T I N G
Test Mode is displayed on the
Barber Pole
TEST MENU
Test Mode is displayed on the
S T A R T E D
is displayed on
.
19