Printek FormsMaster 8000 Operator's Manual page 29

FORM SELECT
/UNLOAD
ALIGN PRINT
form to the tear bar.
This button is used to access up to ten
different forms which have been previously
configured with the Setup menus (see the
chapter on Printer Configuration for more
information).
When this button is pressed, one of two
functions will be performed.
UNLOAD:
If a form is currently in position to be
printed, this button will pull the form
down until the top of the form is below
the top of the tractors. In the
FormsMaster 8003 this will also cause
the tractor shuttle to move forward for
easy access to all tractors.
FORM SELECT:
If the form has already been pulled down
to the tractors as described above, this
button will cycle through all the available
form choices. Forms which are not
considered to be "loaded" in the tractors
will flash
<not loaded>
of the display. In the FormsMaster 8003
the not loaded message will alternate with
the tractor path assigned to that form. For
more information, see the following
section on "Selecting and Loading
Forms".
This button will access the horizontal and
vertical print adjustment settings for the
currently selected form.
When ALIGN PRINT is pressed, the horizontal
adjustment is shown first. Pressing the VALUE
buttons will move the print position on the
line left or right by 0.01 inches for each press
D A I L Y O P E R A T I O N
on the bottom line
23