Printek FormsMaster 8000 Operator's Manual page 11

The factory default settings for each interface should work well for most
installations. However, the following paragraphs provide some basic
information about each interface and also refer to the page number in the
Configuration chapter where all the details for each interface are described. If
you need to make changes to the default settings, please refer to
"Introduction to Setup" on page 39 for instructions on how to access the
printer's Setup menus.
Once you are comfortable that the interface settings match those required by
your computer, proceed to the next section, "Installing the Ribbon
Cartridge" on page 8.
RS-232C Serial Interface
This interface uses a 25 pin "D" connector as described below. The default
settings are 9600 baud, 8 data bits, 1 stop bit, and no parity with hardware
handshake on pin 11. The default printer emulation is Epson. For a
complete description of all the default settings for this interface, refer to page
51.
Pin
11
20
RS-232C Serial Interface Connector.
Signal
1 Chassis ground.
2 Transmit data. (Printer output).
3 Receive data. (Printer input).
4 Request to send (set). (Printer output).
5 Clear to send (ignored). (Printer input).
6 Data set ready (ignored). (Printer
7 input).
8 Signal ground.
Carrier detect (ignored). (Printer input).
Printer busy. (Printer output).
Data terminal ready. (Printer output).
G E T T I N G S T A R T E D
5