Advertisement
7A-10 Heater and Ventilation:
Center Ventilation Louver Removal and
Installation
Removal
1) Disconnect negative (–) cable from battery.
2) Disable air bag system referring to "Disabling Air
Bag System: in Section 8B".
3) Remove passenger air bag module from instrument
panel referring to "Passenger Air Bag (Inflator)
Module Removal and Installation: in Section 8B".
4) Remove radio assembly from instrument panel
referring to "Radio Assembly Removal and
Installation: in Section 9C".
5) Remove center ventilation louver (1) with garnish (2)
from instrument panel, and then disconnect
connector from hazard switch.
NOTE:
Garnish is fitted to instrument panel with six
clips. When removing garnish from
instrument panel, be careful not to break
them.
6) Separate center ventilation louver and garnish.
Installation
Reverse removal procedure.
S4RS0A7106014
1
2
I4RS0A710024-
Side Ventilation Louver Removal and
Installation
Right side ventilation louver
Removal
1) Disconnect negative (–) cable from battery.
2) Disable air bag system referring to "Disabling Air
Bag System: in Section 8B".
3) Remove steering column hole cover from instrument
panel.
4) Remove combination meter cluster panel from
instrument panel, and then disconnect connector
from front fog lamp switch of combination meter
cluster panel.
5) Separate right side ventilation louver (1) and
combination meter cluster (2).
Installation
Reverse removal procedure noting the following
instruction.
• Right side ventilation louver is fitted to combination
meter cluster panel with four clips (1). When installing
right side ventilation louver to combination meter
cluster panel, position the smallest clip to the top.
1
Left side ventilation louver
Removal
1) Disconnect negative (–) cable from battery.
2) Disable air bag system referring to "Disabling Air
Bag System: in Section 8B".
3) Remove glove box from instrument panel.
S4RS0A7106015
1
2
I4RS0A710025-
I4RS0A710026-
Advertisement
