Advertisement
NOTE:
Check that boot is fitted in boot groove
securely all around piston and cylinder.
5) To confirm that boot is fitted in its groove in cylinder
properly, pull piston out of cylinder a little but do not
take it all out.
NOTE:
Boot's face (1) should be at the same level
from cylinder's face (2) all around.
6) Insert piston into cylinder by hand.
Front Disc Brake Caliper Inspection
Pin Boot and Cylinder Boot
Check boots for breakage, crack and damage.
If defective, replace.
Piston Seal
Excessive or uneven wear of pad lining may indicate
unsmooth return of piston.
In such case, replace rubber seal.
Front Brake Disc Removal and Installation
Removal
1) Hoist vehicle and remove wheel.
I2RH01420020-
2) Remove caliper assembly by removing caliper
carrier bolts (2 pcs)
CAUTION:
During removal, be careful not to damage
brake flexible hose and not to depress brake
pedal.
NOTE:
Hang removed caliper with a wire hook or the
like so as to prevent brake hose from
bending and twisting excessively or being
pulled.
Don't operate brake pedal with brake pads
removed.
I4RS0A420004-
S4RS0A4206007
3) Pull brake disc off by using 8 mm bolts (1) (2 pcs).
I2RH01420014-
Front Brakes:
4B-6
I2RH01420015-
S4RS0A4206008
I2RH01420024-
I2RH01420025-
Advertisement
