Advertisement
Power Door Mirror Control System (If Equipped) Symptom Diagnosis
Condition
All power mirrors do not
operate
One power mirror does
not operate
Windshield Removal and Installation
Removal
1) Clean both inside and outside of glass and around it.
2) Remove wiper arms and cowl top garnish.
3) Remove windshield side garnish.
4) Using tape, cover body surface around glass to
prevent any damage.
5) Remove rear view mirror, sun visor and front pillar
trims (right & left).
6) If necessary, remove instrument panel. Refer to
"Instrument Panel Removal and Installation: in
Section 9C".
7) If necessary, remove head lining. Refer to "Head
Lining Removal and Installation: in Section 9H".
8) Remove (or cut) windshield molding.
9) Drill hole with eyeleteer (1) through adhesive and let
piano string through it.
10) Cut adhesive all around windshield (1) with piano
string (2). When using tool, windshield knife (3), to
cut adhesive, be careful not to cause damage to
windshield. Use wire to cut adhesive along lower
part of windshield.
Possible cause
Circuit fuse blown
Power door mirror switch faulty
Wiring or grounding faulty
Power door mirror switch faulty
Power door mirror actuator faulty
Wiring or grounding faulty
Repair Instructions
S4RS0A9506001
I2RH01950040-
Glass / Windows / Mirrors:
Correction / Reference Item
Replace fuse and check for short circuit.
Check power door mirror switch referring to
"Power Door Mirror Switch Inspection: ".
Repair circuit.
Check power door mirror switch referring to
"Power Door Mirror Switch Inspection: ".
Check actuator refraining to "Power Door
Mirror Actuator Inspection: ".
Repair circuit.
NOTE:
Use piano string (2) as close to glass as
possible so as to prevent damage to body
and instrument panel.
11) Using knife (1), smoothen adhesive (2) remaining on
body side (3) so that it is 1 – 2 mm (0.039 – 0.078
in.) thick all around.
9E-3
S4RS0A9504003
I3RH0A950006-
Advertisement
