Differential Assembly Disassembly and
Reassembly
Disassembly
1) Remove final gear bolts (1), and then final gear (2).
2) Remove differential side RH bearing by using special
tools.
Special tool
(A): 09926–37610
(B): 09926–37610–001
(C): 09926–37610–003
(D): 09926–37610–002
3) Remove output shaft speed sensor (VSS) drive gear
(1).
2. Differential case subassembly
4) Remove differential side LH bearing by using special
tools.
Special tool
(A): 09926–37610
(B): 09926–37610–001
S4RS0A5106053
(C): 09926–37610–003
(D): 09926–37610–002
I2RH0B510225-
Reassembly
WARNING:
• When taking warmed final driven gear out
of vessel, use tongs or the like. Taking out
it with bare hand will cause severe burn.
• While installing warmed final driven gear,
use oven glove such as leather glove.
Picking up it with bare hand may cause
burn.
CAUTION:
Do not leave final driven gear in boiling water
for longer than 5 min. Overheating the gear
may cause strength reduction of gear.
1) Put final driven gear in water vessel, heat and
I2RH0B510226-
remove when it boils, then remove moisture.
NOTE:
After removing moisture on final driven gear,
install final driven gear to differential case as
quickly as possible.
I2RH0B510227-
Automatic Transmission:
5A-143
I2RH0B510228-
I2RH0B510229-