Advertisement
9J-2 Hood / Fenders / Doors:
Front Fender Components
1. Front fender lining
Front Fender Removal and Installation
Removal
1) Remove splash guard (if equipped) referring to "Splash Guard (If Equipped) Components: in Section 9H".
2) Remove front fender lining.
3) Remove front bumper referring to "Front Bumper and Rear Bumper Components: in Section 9K".
4) Remove headlight assembly referring to "Headlight Housing Removal and Installation: in Section 9B".
5) Disconnect connector from side turn signal lamp.
6) Remove front fender cover.
7) Remove front fender.
Installation
Reverse removal procedure to install front fender noting the following instruction.
• If paint on fender bolt is peeled off, be sure to apply paint again.
• Adjust panel clearance referring to "Panel Clearance: in Section 9K".
1
2. Front fender
3
2
3. Front fender cover
S4RS0A9A06003
I4RS0A9A0003-
S4RS0A9A06004
Advertisement
