Advertisement
10B-14 Body Electrical Control System:
4) Read DTC according to instructions displayed on SUZUKI scan tool and print it or write it down.
Refer to SUZUKI scan tool operator's manual for further details.
If communication between SUZUKI scan tool and BCM is not possible, check if SUZUKI scan tool is
communicable by connecting it to BCM in another vehicle. If communication is possible in this case, SUZUKI scan
tool is in good condition. Then check data link connector and serial data line (circuit) in the vehicle with which
communication was not possible.
5) After completing the check, turn ignition switch off and disconnect SUZUKI scan tool from data link connector.
Without Using SUZUKI Scan Tool
1) Turn ignition switch to OFF position.
2) Perform following Steps a) to d) within 10 seconds after ignition switch is turned ON and engine stops.
a) Turn headlight switch to "SMALL" position.
b) Turn headlight switch to "OFF" position.
c) Repeat Steps a) and b) 2 times.
d) Press and release driver side door switch 3 times.
3) Check DTC displayed on odometer of combination meter or read flashing pattern of alarm indicator lamp which
represents DTC as shown in the following example and write it down.
When more than 2 DTCs are stored in memory, flashing for each DTC starts with the smallest DTC number in
increasing order. Also, DTC is indicated repeatedly until the ignition switch is turned OFF.
[A]
A
B
[B]
A
B
[C]
A
B
[A]: No DTC (No. 0000)
[B]: DTC B1133 (No. 1133)
[C]: When 2 DTCs are detected
A: Indicator lamp turned ON
4) After completing the check, turn ignition switch to OFF position.
0
0
0
T2
T2
T2
T2
1
1
3
3
T2
T2
T2
T1
T1
T1
T1
1
1
3
3
T2
T2
T2
T1
T1
T1
T1
0
1
1
T3
T2
T2
T1
T1
B: Indicator lamp turned OFF
T1: 0.3 seconds
T2: 1.0 seconds
T3: 3.0 seconds
1
2
6
0
T2
T2
T1
1. Alarm indicator lamp
2. Odometer
I4RS0AA20007-
Advertisement
