Advertisement
Installation
1) Install rear wiper motor (1) and tighten rear wiper
motor mounting bolts to specified torque.
Tightening torque
Rear wiper motor mounting bolt (a): 8 N·m (0.8
kg-m, 6.0 lb-ft)
2) Connect coupler to rear wiper motor
3) Install rear end door trim referring to "Rear End Door
Lock Assembly Removal and Installation: in Section
9F".
4) Install rear wiper seal (1), and tighten rear wiper nut
to specified torque.
Tightening torque
Rear wiper nut (a): 5 N·m (0.5 kg-m, 4.0 lb-ft)
5) Install rear wiper pivot cap (2).
2
(a)
6) Install rear wiper arm with blade assembly (1) to
specified position as shown in figure.
2. Rear wiper blade
3. Ceramic line
I4RS0A940014-
1
I4RS0A940015-
I4RS0A940016-
7) Tighten rear wiper arm nut to specified torque, and
then install arm cover (1).
Tightening torque
Rear wiper arm nut (a): 8 N·m (0.8 kg-m, 6.0 lb-ft)
1
(a)
8) Connect negative (–) cable to battery.
Rear Wiper Motor (If Equipped) Inspection
NOTE:
Make sure that battery voltage is 12 V or
more.
1) Make a mark (1) on rear wiper motor (2) stop
position as shown.
2) Check rear wiper motor for operation as follows.
• For motor operation
a. Connect battery positive terminal to terminal
"1" and its negative terminal to terminal "2".
b. Check motor revolution speed as
specification. If check result is not as
specified, replace motor.
Specification
35 – 45 r/min (rpm)
1
2
3
Wipers / Washers:
9D-6
I4RS0A940017-
S4RS0A9406005
I4RS0A940018-
I4RS0A940019-
Advertisement
