Advertisement
A: Vehicle body side (Upper side)
F: Front side
3. Stepped part
2) Install coil spring referring to "Coil Spring Removal
and Installation: ".
Rear Axle Removal and Installation
Removal
1) Hoist vehicle and remove rear wheels (right & left)
referring to "Wheel Removal and Installation: in
Section 2D".
2) Remove rear brake drums (right & left). For details,
refer to Steps 2) to 6) of "Rear Brake Drum Removal
and Installation: in Section 4C".
3) Disconnect brake pipes (1) from brake hoses (2) and
remove E-rings (3).
CAUTION:
Do not allow brake fluid to get on painted
surfaces
1
1
4) Disconnect brake pipe flare nuts (1) from wheel
cylinders (3) (right & left) and put bleeder plug cap
(4) onto pipe (2) to prevent fluid from spilling.
CAUTION:
Do not allow brake fluid to get on painted
surfaces.
5) Disconnect wheel speed sensors (5) and lead wire
clamps (6) (right & left) (if equipped).
6) Remove brake back plates (7) and spindles (right &
left) from rear axle and hang removed brake back
plate with a wire hook.
I4RS0A230017-
LH: Left side
RH: Right side
S4RS0A2306035
3
2
2
3
I4RS0A230018-
6
5
7) Support rear axle (1) by using two floor jacks (2).
1
2
8) Remove shock absorber lower washers and nuts (1)
(right & left).
Rear Suspension:
2C-7
3
1
7
2
4
I4RS0A230043-
2
I4RS0A230009-
1
I4RS0A230019-
Advertisement
