Advertisement
4) Install bleeder plug cap (4) taken off from pipe back
to bleeder plug.
(a)
1
2
5) Install brake shoes. Refer to "Rear Brake Shoe
Removal and Installation: ".
6) Install brake drum. Refer to "Rear Brake Drum
Removal and Installation: ".
7) Fill reservoir with brake fluid and bleed brake
system. For bleeding operation refer to "Air Bleeding
of Brake System: in Section 4A".
8) Upon completion of all jobs, depress brake pedal
with about 300 N (30 kg, 66 lbs) load 3 to 5 times so
as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable.
9) Install wheel and tighten wheel nuts to specified
torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kg-m, 61.5 lb-ft)
10) Check to ensure that brake drum is free from
dragging and proper braking is obtained. Then
remove vehicle from hoist and perform brake test
(foot brake and parking brake).
11) Check each installed part for fluid leakage.
Wheel Cylinder Inspection
Inspect wheel cylinder disassembled parts for wear,
cracks, corrosion or damage.
NOTE:
Clean wheel cylinder components with brake
fluid.
Brake Back Plate Removal and Installation
Removal
1) Remove brake drum referring to "Rear Brake Drum
4
Removal and Installation: ".
(b)
2) Remove brake shoe referring to "Rear Brake Shoe
Removal and Installation: ".
3) Remove wheel cylinder referring to "Wheel Cylinder
Removal and Installation: ".
4) Remove parking brake cable (1) from brake back
3
plate.
I4RS0A430018-
5) Remove rear wheel speed sensor (1) from brake
back plate.
6) Remove spindle bolt (2), and remove brake back
plate (3) and spindle.
S4RS0A4306007
I4RS0A430019-
Rear Brakes:
1
1
3
2
2
4C-6
S4RS0A4306008
I4RS0A430020-
I4RS0A430021-
Advertisement
