Advertisement
• Move door latch striker (2) up or down so its center
aligns with the center of groove "A" on the door lock
assembly (1) as shown.
Striker should be moved vertically and placed level.
Do not adjust door lock.
Tightening torque
Door latch striker screw (a): 10 N·m (1.0 kg-m, 7.5
lb-ft)
3. Shaft
• Move door latch striker (1) sideways to adjust door
outer panel surface (2) flush with rear door outer
panel or body outer panel surface (3) as shown.
In order to correctly obtain door lock operation
increase or decrease number of shims inserted
between body and striker (1) to adjust it.
[A]: Front door
[B]: Rear door
Front Door Lock Assembly Inspection
• Check that door open and closes smoothly and
properly.
• Check that door stops in the secondary latched
position properly (preventing door from opening
freely) and that door closed completely in the fully
latched position.
• Adjust door latch striker position, if necessary.
Power Door Lock Switch Inspection
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
I4RS0A960029-
I3RM0A960013-
Security and Locks:
1. Power door lock switch
9F-7
S4RS0A9606019
S4RS0A9606003
I4RS0A960009-
Advertisement
