Connect Platen; Remove Wipers; Install Wipers; Remove Displacement Pump - Graco D200 Repair Manual

Repair

Connect Platen

30 and 55 Gallon Platen
1. Place o-ring (428) from mounting kit 255392 on the
platen. If attached to plate, place displacement
pump onto platen. See F
2. Secure pump's intake flange to plate with screws
(426), washers (425), and clamps (427) included in
mounting kit 255392.
20, 30, and 60 Liter Platen
Before installing the 20, 30, or 60 liter platen to a
pump with an intake adapter, install adapter and
o-ring from mounting kit 257630 using the two set
screws. See F . 19.
IG
1. Place o-ring (473) from mounting kit 257630 on
pump intake. Loosen mounting bracket screws
(401) and carefully lower pump onto o-ring (463)
and platen.
2. Secure pump's intake flange to plate with screws
(401).

Remove Wipers

See Remove and Reinstall Wipers on page 17.

Install Wipers

See Remove and Reinstall Wipers on page 17.
24
. 18.
IG

Remove Displacement Pump

The procedure for removing your displacement pump
depends on which air motor and platen your unit uses.
Find your ram unit, air motor, and platen below to
remove the displacement pump. Refer to your
Check-Mate Displacement Pump 312376 manual to
repair the displacement pump.
If the air motor does not require servicing, leave it
attached to its mounting. If the air motor does need to
be removed, see page 27.
D200 3 in. and D200s 6.5 in. Supply Units
NXT Air Motors:
1. See Disconnect Displacement Pump in
Check-Mate Pump Packages manual 312376.
2. Raise the air motor:
a. For NXT 2200-6500 with 55 gallon platen:
Loosen nut (105a) under ram bar and thread it
down the threaded rod (106) to the lift ring
adapter (107) holding the motor. Use wrench on
nut (105) on top of ram bar to raise air motor.
105
105a
F . 20
IG
106
107
TI10648A
313527ZAD