Remove And Reinstall Wipers - Graco D200 Repair Manual

Maintenance Procedures
Use platen with straight sided pail
1. Ensure large diameter of spacer (EG) is facing
down. Work spacer (EG) up over the platen by
hand completely above the flange of the platen. See
F . 12.
IG
2. Working from the top, use screwdriver to position
spacer (EG) between flange and wipers (EB). See
F . 13.
IG
EB
F . 12: Sliding spacer
IG
EG
EB
F . 13: Installing Spacer
IG
18

Remove and Reinstall Wipers

Disassemble 20, 30, and 60 Liter Wiper
Assemblies
1. Remove wiper assembly; see F
EG
2. Remove eight nuts (459) on wiper assembly.
3. Separate top plate (457), spacer (452), wiper(s)
r_255468_313527_30a
4. Clean, inspect, and replace worn components.
r_255468_313527_32a
a. For all single wiper platens: Remove two clips
(470) with needle nose pliers and remove platen
cover (469).
b. Remove eight nuts (459) that hold wiper assem-
bly to platen casting (451) and remove wiper
assembly.
c. See Reassemble 20, 30, and 60 Liter Wiper
Assemblies to change wiper sizes, styles, or a
complete wiper assembly.
(453), wiper support (454), and bottom plate (455).
. 14:
IG
313527ZAD