Install Air Motor - Graco D200 Repair Manual

Install Air Motor

D200 3 in. and D200s 6.5 in. Supply Units
NXT with 55 gallon platen:
1. For NXT2200-6500: Using a capable hoist, insert tie
rods into displacement pump and secure air motor
to pump.
a. See Reconnect Displacement Pump in
Check-Mate Pump Packages manual 312376.
b. Install threaded rod (106) through center hole in
the crossbar. Install lock washers (104) and
nuts (105) onto threaded rod (106), both above
and below crossbar. Use wrench to hold lift ring
adapter (107) and tighten threaded rod (106)
into lift ring adapter (107) using another wrench.
See F . 30.
IG
c. Tighten nut (105) below crossbar to 25 ft-lb (34
N•m) maximum.
d. Tighten nut (105) above crossbar to lock motor
in place.
105
104
F . 30
IG
313527ZAD
2. For NXT200-1800: Attach motor to mounting
3. Connect air hose to motor. If using a remote Data-
NXT with smaller platens:
4. Position mounting plate (109) to ensure top of motor
Xtreme XL Air Motors
1. Using a capable hoist, lower air motor on the mount-
2. Secure motor to mounting plate (109) with nuts
3. Install cross bar (1c), nuts (103), and washers (102).
4. See Reconnect Displacement Pump in
106
5. Connect air hose to motor. If using a remote Data-
105
107
TI10649A
bracket with screws (111) and washers (110). See
F . 25 on page 27.
IG
Trak, connect electrical connections to the air
motor. See F . 22 and F
IG
will clear the crossbar. See F
hoist, attach motor to mounting plate (109) using
screws (111) and washers (110).
a. See Reconnect Displacement Pump in
Check-Mate Pump Packages manual 312376.
b. Connect air hose to motor. If using a remote
DataTrak, connect electrical connections to the
air motor. See F . 25 on page 27.
IG
ing plate (109). See F . 29.
IG
(114) and washers (113).
Check-Mate Pump Packages manual 312376.
Trak, connect electrical connections to the air
motor. See F . 22 on page 26.
IG
Repair
. 23 on page 26.
IG
. 26. Using a capable
IG
29