Remove Air Motor - Graco D200 Repair Manual

Remove Air Motor

NXT Air Motors
1. See Disconnect Displacement Pump in
Check-Mate Pump Packages manual 312376.
2. Disconnect air hose from air motor. If using a
remote DataTrak, detach electrical connections
from the air motor.
3. Disconnect air motor:
a. For NXT 2200-6500 with 55 gallon platen (D200
3 in. and D200s 6.5 in. supply units): Loosen nut
(105a) below crossbar. Use wrench to hold lift
ring adapter (107) in place and loosen threaded
rod (106) above crossbar with another wrench.
See F . 24.
IG
106
105
F . 24: NXT 2200-6500 with 55 Gallon Platen
IG
b. For NXT 200-1800 with 55 gallon platen (D200
3 in. and D200s 6.5 in. supply units): Remove
screws (111) and washers (110) securing motor
to mounting plate. See F
313527ZAD
105a
107
TI11169A
. 25.
IG
110
111
F . 25: NXT 200-1800 with 55 Gallon PLaten
IG
c. For NXT with smaller platen (D200 3 in., D200s
6.5 in., and D60 3 in. supply units): Remove
screws (111) and washers (110) securing motor
to mounting plate.
110
111
F . 26: NXT on D200 with Small Platen
IG
r_255648_313527_15a
F . 27: NXT on D60 with Ram
IG
Repair
r_255648_313527_9a
TI10786A
109
110
111
27