Omron NX701-1700 User Manual page 51

 Support Software
You can use the following Support Software to set up, monitor, and debug an NX-series Controller.
• Sysmac Studio
The Sysmac Studio is the main Support Software that you use for an NX-series Controller. On it,
you can set up the Controller configurations, parameters, and programs, and you can debug and
simulate operation.
• Other Support Software
The following Support Software is also included in the Sysmac Studio Software Package Standard
Edition.
Configuration software
Sysmac Studio
Network Configurator
CX-Integrator
CX-Protocol
CX-Designer
*1. If the NJ/NX-series Controller is a target device, you may also use Sysmac Studio version 1.10 or higher. Use
the Network Configurator if a CS/CJ-series PLC operates as the originator device.
NX-series CPU Unit Hardware User's Manual (W535)
The Sysmac Studio is used for sequence control, motion control, and all other
operations except those described below.
The Network Configurator is used for tag data links on EtherNet/IP ports.
The CX-Integrator is used for remote I/O communications with a CJ-series Devi-
ceNet Unit or CJ-series CompoNet Master Unit.
The CX-Protocol is used for protocol macros with the CJ-series Serial Communi-
cations Units.
The CX-Designer is used to create screens for NS-series PTs.
1 Introduction to NX-series Controllers
Application
1
*1
1 - 7