Omron NX701-1700 User Manual page 204

5 Troubleshooting
Event name SD Memory Card Program Transfer Failed to Start
Meaning An error was detected in pre-start checks for transferring SD Memory Card programs.
Source PLC Function Module
Error attributes Level
Effects User program
System-defined Variable
variables
_Card1PrgTransferSta
Cause and Assumed cause
correction
Program transfer by system-defined
variable is set to Do not use in the
Controller Setup.
Password of Program transfer by sys-
tem-defined variable in the Controller
Setup does not agree with the
_Card1PrgTransferCmd.Password
system-defined variable.
The DIP switch on the CPU Unit is not
set to allow starting the SD Memory
Card program transfer.
An SD Memory Card is not inserted.
The SD Memory Card type is not cor-
rect.
The format of the SD Memory Card is
not correct.
There is no such folder on the SD
Memory Card as specified by the
_Card1PrgTransferCmd.DirName sys-
tem-defined variable.
There are no backup files in such a
folder on the SD Memory Card as
specified by the _Card1PrgTransfer-
Cmd.DirName system-defined vari-
able.
Either the backup files in the folder
specified by the _Card1PrgTransfer-
Cmd.DirName system-defined vari-
able on the SD Memory Card are
corrupted or required data is not in the
backup files on the SD Memory Card.
5 - 68
Source details
Observation Recovery
--- Operation
Data type
_sPRGTRANSFER_STA
Correction
Set Program transfer by system-
defined variable to Use in the Control-
ler Setup.
Set Password of Program transfer by
system-defined variable in the Con-
troller Setup to the _Card1PrgTrans-
ferCmd.Password system-defined
variable.
Turn OFF all pins on the DIP switch of
the CPU Unit, and then start the SD
Memory Card program transfer.
Insert an SD Memory Card.
Replace the SD Memory Card with an
SD or SDHC card.
Format the SD Memory Card with the
Sysmac Studio, create a folder speci-
fied by the _Card1PrgTransfer-
Cmd.DirName system-defined
variable on the card, and store the
backup files in the folder.
Create a folder specified by the
_Card1PrgTransferCmd.DirName
system-defined variable on the SD
Memory Card and store the backup
files in the folder.
Replace the backup files in the folder
specified by the _Card1PrgTransfer-
Cmd.DirName system-defined vari-
able.
If this error occurs again even after
replacing the files, create the backup
files again and place them in the
folder specified by the _Card1Prg-
TransferCmd.DirName system-
defined variable.
Event code
1032 0000 hex
None Detection
timing
--- Log category
Not affected.
Name
SD Memory Card Program Transfer
Status
Prevention
Set Program transfer by system-
defined variable to Use in the Control-
ler Setup.
Set Password of Program transfer by
system-defined variable in the Con-
troller Setup to the _Card1PrgTrans-
ferCmd.Password system-defined
variable.
Turn OFF all pins on the DIP switch of
the CPU Unit, and then start the SD
Memory Card program transfer.
Insert an SD Memory Card.
Use an SD or SDHC card.
Use a formatted SD Memory Card,
create a folder specified by the
_Card1PrgTransferCmd.DirName
system-defined variable on the card,
and store the backup files in the
folder.
Also, do not remove the SD Memory
Card or turn OFF the power supply
while the SD BUSY indicator is lit.
NX-series CPU Unit Hardware User's Manual (W535)
*1
When transfer-
ring SD Memory
Card programs is
started
System