Furuno FAR-3210 Installation Manual page 77

4. Fasten the BNC case to the antenna unit with two screws. Connect the coaxial ca-
ble to the BNC case then pass it through the locking wire saddle circled below.
5. Fasten the converter to the transceiver unit with four screws at the locations cir-
cled below.
6. Unfasten the two screws from the cover plate that hides the SPU board. Connect
the power cable (supplied) to the converter. Pass the cable through the two lock-
ing wire saddles circled below then connect the cable to J824 on the SPU board.
Close the cover plate.
Coaxial cable Coaxial cable
LAN Signal Converter LAN Signal Converter
2. WIRING
J824 J824
2-49