Furuno FAR-3210 Installation Manual page 34

2. WIRING
Note 2: If the deicer is to be installed, spread open the right and left heater ele-
ments on the cover, then remove the front cover, being careful not to hit the ele-
ments on the radiator or chassis.
Note 3: If this a retrofit or foremast installation, a LAN Signal Converter is re-
quired, in both the antenna unit and the power supply unit. See section 2.7.
2. Disconnect the performance monitor connector (J807) and the motor drive con-
nectors (J803, J804 and J808) from the RF-TB Board.
3. Unfasten the six bolts circled in the figure below to enable removal of the trans-
ceiver unit.
4. Pull the handle on the transceiver unit to remove the unit. Lay the unit on its side
or on top of non-ferrous material, to prevent demagnetization of the magne-
tron.
2-6
J808 J808
J803 J803
(motor) (motor)
(motor) (motor)
J807
(performance monitor)
J804 (motor) J804 (motor)