Furuno FAR-3210 Installation Manual page 41

13. Close the cable entrance cover as shown in the figure below.
Coat the hinge inside the
gasket with adhesive, to
prevent water from
leaking into the cover.
14. Fix the cable cover with four screws, then coat the screws with adhesive.
15. Connect the performance monitor connector (J807) to the rear cover.
16. Check that the gasket on the front and rear covers is seated properly, then
close the covers. The torque for the fixing bolts is 10.0 N•m.
Note 1: If it is necessary to open the front cov-
er after installing the de-icer kit, remove the
power cable from the locking wire saddle
shown in the right figure then detach the cover
slowly to prevent damage to the heater ele-
ment.
Note 2: Take care not to hit the heater ele-
ments on the chassis or radiator. If the heater hits something, unfasten the fixing
screws for the heater to adjust the position of the heater. Then fix the heater again.
Cable entrance
cover
Adhesive
Close cover then coat screw
heads with adhesive.
Remove cable from locking wire Remove cable from locking wire
saddle to open front cover. saddle to open front cover.
2. WIRING
2-13