Furuno FAR-3210 Installation Manual page 40

2. WIRING
5) Coat the gasket (all brims) of the intake with the supplied oil compound. Be
sure to coat the gasket completely.
6) Set the front cover to the antenna unit. Take care not to hit the heater ele-
ments on the chassis or radiator.
7) Use M5 screws (supplied) to fasten the base of the heater. Fasten the instal-
lation materials shown in the following figure to each of the cover bolts.
8) Attach the supplied earth label over the earth label currently attached near the
grounding terminal.
12. Position the cables so their armors lie beneath their respective cable clamp plates
in the cable entrance. Fasten the plates.
2-12
Intake Intake
Brim Brim
M5 screw M5 screw
Earth
label
Hatch: Oil compound
Fixing Fixing
shaft shaft
Grounding Grounding
terminal terminal
M5 screw M5 screw
Cover bolt Cover bolt