Furuno FAR-3210 Installation Manual page 61

Connections
Unfasten four screws to remove the cover. Pass the cables through the clamps and
attach the cables to respective connectors. The shield (or drain wire) must lie in (con-
nected to) the clamp.
Note: Be sure each cable shield lies in the cable clamp.
How to set NC/NO output (J2)
The POWER FAIL signal on the connector J2 can be set to NC (normal close) output
or NO (normal open) output as shown in the table below.
Pin # Signal name
1 24V_IN
2 24V_GND
3 PWR_FAIL_A
4 PWR_FAIL_COM
5 PWR_FAIL_B
J9 J9
J7 J7
J8 J8
J5 J5
J6
J4
J1 J1
J2 J2
TTYCS-4/
TTYCSLA-4 TTYCSLA-4
MC1.5-W-L cable MC1.5-W-L cable
DPYC1.5 DPYC1.5
Connector J2
In/Out
- 24 VDC
- GND (24 VDC)
Out Power fail output
Out Power fail output
Out Power fail output
For TTYCSLA cables, attach a shrinking
tube (local supply), to drain wire, then use
these crimp-on lugs and screws
to connect the drain wire here.
FR-FTPC-CY cable FR-FTPC-CY cable
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
TTYCS-1Q/ TTYCS-1Q/
TTYCSLA-1Q TTYCSLA-1Q
Remarks NO
DPYC-1.5
TTYCS(LA)-1
No connection
2. WIRING
NC
No connection
TTYCS(LA)-1
2-33