Furuno FAR-3210 Installation Manual page 39

Note 1: A terminal opener is provided on the RF-TB Board.
Note 2: For the antenna cable RW-9600, connect the crimp-on lug (that binds un-
used wires) together with the shield of the power line. See *1 on page 2-8 for the
location.
11. DE-ICER INSTALLATION. If the de-icer is not provided, go to step 12.
See also "X-band De-icer Kit Installation Instructions", issued separately, for the
de-icer not fitted at the factory.
DEICER Board
(03P9573)
Front cover, inside view
1) Set a locking wire saddle (supplied) at locations (2) and (3) shown below.
Pass the power cable through the locking wire saddles (1), (2) and (3) and pull
it to the front side.
2) Unfasten the cable band*. Pass the ca-
ble for the de-icer through the band
then fasten the band. Connect the ca-
ble to TB901 on the DE-ICER board,
using the crimp-on lugs supplied.
* For the DE-ICER installation kit, un-
fasten the cable band on the cover
supplied. (The original cover can be
discarded.)
3) Set the Voltage Selection switch ac-
cording to the power source for the de-
icer; 115 V or 230 V.
4) Apply power to the deicer then press
the [TEST] button about ten seconds.
Check that the heater gets hot.
DEICER Board (03P9573)
2. WIRING
[TEST] button [TEST] button
TB901 TB901
Voltage Selection switch
03P9573
TB901
Cable band Cable band
2-11