4-6
Configuring the Subscriber
Unit's Transmit Power Level
and Maximum Data Rate
The following sections describe how to configure the transmit power level
and maximum data rate for Subscriber Units. The Initial Transmit
Power level should be configured only when the Transmit Power Control
Algorithm is disabled.
Configuring the Initial Transmit Power
Level
If the Transmit Power Control Algorithm is enabled you can retain the
default configuration of the Initial Transmit Power parameter, since the
algorithm automatically sets the optimal level of the output power.
If the Transmit Power Control Algorithm is disabled, it is recommended
that the Initial Transmit Power parameter for each SU be set to achieve
an SNR of 26 dB at the AU. Refer to Table 4-2 for the list of optimal
transmit power levels at various distances, assuming a free line of sight
between SU and AU.
BreezeACCESS VL System Manual