Working With The Monitor Program; Accessing The Monitor Program Using Telnet - Alvarion BreezeACCESS VL 5.4 System Manual

5-2
Working with the Monitor
Program
Accessing the Monitor Program Using
Telnet
1.
Connect a PC to the Ethernet port, using a crossed cable.
2.
Configure the PC's IP parameters to enable connectivity with the unit.
The default IP address is 10.0.0.1.
3.
Run the Telnet program. The Select Access Level menu is displayed.
Select the required access level, depending on your specific access
rights. A password entry request is displayed. Table 5-1 lists the
default passwords for each of the access levels.
NOTE:
Following three unsuccessful login attempts (using incorrect passwords), the monitor
program is blocked for several minutes. To enable access to the monitor program during
that time, the unit must be reset via SNMP or by disconnecting/reconnecting power.
4.
Enter your password and press Enter. The Main Menu is displayed as
shown in Figure 5-1. The unit type, SW version number and SW
release date displayed in the Main Menu vary according to the selected
unit and SW version.
NOTE:
If the Telnet session is not terminated properly, for example, if you simply close the
window, the monitor program is blocked for several minutes. To enable access to the
monitor program during that time, the unit must be reset via SNMP or by
disconnecting/reconnecting power.
Table 5-1: Default Passwords
Access Rights Password
Read Only Public
Installer User
Administrator Private
BreezeACCESS VL System Manual