Unit Control Menu - Alvarion BreezeACCESS VL 5.4 System Manual

Operation and Administration

Unit Control Menu

The Unit Control menu enables configuring control parameters for the unit.
The Unit Control menu includes the following options:
Reset Unit
The Reset Unit option enables resetting the unit. After reset, any
modifications made to the system parameters are applied.
Set Defaults
The Set defaults submenu enables resetting the system parameters to a
predefined set of default or saving the current configuration as the set of
Operator Defaults. The available options are:
Set Defaults:
The Set Defaults submenu enables reverting the system parameters to a
predefined set of defaults. There are two sets of default configurations:
a. Factory Defaults: This is the standard default configuration.
b. Operator Defaults: Operator Defaults configuration can be
defined by the Administrator using the Save Current
Configuration As Operator Defaults option in this menu. It may
also be defined at the factory according to specific operator's
definition. The default Operator Defaults configuration is the
Factory Defaults configuration.
The current configuration file and the Operator Defaults configuration file
can be uploaded/downloaded by the unit using FTP. For more information
see Configuration File Upload/Download option on page 5-13. These files
can also be uploaded/downloaded remotely using TFTP (see Appendix B).
The available options in the Set Defaults submenu are:
♦ Set Complete Factory Defaults: Available only with Administrator
access rights. Resets the unit to the standard Factory Defaults
configuration, excluding the Administrator Password.
♦ Set Partial Factory defaults: Resets the unit to the standard Factory
Default configuration, excluding the parameters that are required to
maintain connectivity and management access. These parameters are
listed in Table 5-2.
5-9