Figure 3-5: Indoor Unit Front Panel - Alvarion BreezeACCESS VL 5.4 System Manual

3-10
3.
Connect the power cord to the unit's AC socket, located on the rear
panel shown in Figure 3-6 on page 3-10. Connect the other end of the
power cord to the AC mains after verifying that the unit is rated for
the voltage in the country of use; the AC rating is indicated on the
rear panel of the Indoor unit.
NOTE:
The color codes of the power cable are:
brown
phase ~
blue
neutral 0
yellow/green
grounding
4.
Verify that the yellow POWER LED located on the front panel is lit,
indicating that the unit is supplying power to the radio port.
5.
Configure the basic parameters as described in Configuring Basic
Parameters on page 4-2.
6.
Connect the 10/100 BaseT connector located on the front panel of the
unit to the network. The cable connection should be straight Ethernet
if connecting the indoor unit to a Hub/Switch and a crossed cable if
connecting it directly to a PC Network Interface Card (NIC).

Figure 3-5: Indoor Unit Front Panel

Figure 3-6: Indoor Unit Rear Panel
BreezeACCESS VL System Manual