Configuring Basic Parameters - Alvarion BreezeACCESS 900 Installation Manual

Preliminary Configuration

Configuring Basic Parameters

The Basic Configuration menu of the Monitor program includes all the
parameters necessary for the initial operation of BreezeACCESS SU-M-900.
YOU MUST PERFORM A SITE SURVEY AND SPECTRUM SWEEP PRIOR TO
CONFIGURING THE AU'S IN ORDER TO DETERMINE THE AVAIABLE
CLEAR CHANNELS.
The following list includes the basic parameters and their default values
(applies to Version 4.3.9):
Parameter
IP Address
Subnet Mask
Default Gateway Address
Transmit Antenna
ESSID
Hopping channels
Best AU Support
Best AU scanning time
Scan Entire band
Max number of Bad Synch
Max number of Assoc/Auth
TimeOut
Number of Dwells to
retransmit
Max TX Data Rate
Operator ESSID
Once the basic parameters are configured, the unit must be reset to
activate the new configuration.
Default Value
10.0.0.1
255. 0.0. 0
0.0.0.0
Antenna 2 in
software. DO NOT
CHANGE
ESSID1
None
enable
Set to 7
Disable
Set to 115
Set to 100
Set to 1
Set to 2 Mbps
Disable
Comment
USE ANT 1 PHYSICAL
PORT, ANT 2 NOT
CONNECTED.
Must be the same as the
ESSID the Base Station AU.
Configure according to site
survey results
Set scanning time
Makes roam decision faster
Set only to channels used
in all AUs
Improves roaming
performance in edge areas
Improves throughput by
limiting multi-rate
algorithm
Enable if using operator
ESSID on all AU cells.
3-3