HELIX HR3500 Assembly Manual page 14

PAGE 14
STEP 8a:
ASSEMBLE CONSOLE
Thread the wires from the console #6 through the hole
in the center of the console mounting bracket #7. Set the
bracket into place on the console, and secure the 4 console
mounting bolts #26, as shown in Figure #5. Do not over-
tighten these bolts.
(#26) M5x15 Bolt x 4
(#30) S6 x1
5
6
7
HR3500 manual.indd 14
PLEASE TAKE SPECIAL CARE NOT TO PINCH THE WIRES
26
ASSEMBLY INSTRUCTIONS
STEP 8b:
ASSEMBLE CONSOLE
Install the bolt and connect the four wires as shown in
Figure #6.
Carefully feed the wires and their connectors back into the
console or upright post to avoid pinching or pulling them.
Note that enough slack must be left in the wires to allow
the console position to be changed.
(#25) M8x92 Bolt x 1
(#20) M8 Washer x 2
(#24) M8 Nut x 1
6
6
20 24
20
25
3
(#29) S5 x1
(#32) S10, S13, S14, S17 x 1
3
20/09/2017 18:47