Step 4: Assemble Pedal; M8X19 Bolt - HELIX HR3500 Assembly Manual

PAGE 10
STEP 4:
ASSEMBLE PEDAL
The pedals have two bolts pre-installed and require two Hex head bolts from the Step 4 hardware pack.
While holding the pedal frame up to the crank arm, thread the lower left and lower right hex head bolts through the round
flange on the pedal frame and into the round flange on the crank arm. This will allow the pedal to hang on the crank arm.
Then thread the top two pre-installed bolts into the crank arm assembly round plate.
Continue threading all 4 bolts into the crank arm assembly flange until they are all snug and the flanges are flush together.
Now tighten all 4 bolts very firmly. Repeat for the other pedal assembly.
(#19) M8x19 Bolt x8
(#20) M8 Washer x 8
(#32) S10, S13, S14, S17 x 1
IT IS CRITICAL THAT A FULL VISUAL INSPECTION BE COMPLETED
TO ENSURE THAT THE PEDAL FRAME ROUND FLANGE & THE
CRANK ASSEMBLY ROUND FLANGE ARE FLUSH TOGETHER AND
THAT ALL FOUR BOLT ARE COMPLETELY & FIRMLY INSTALLED.
Failure to ensure that the two flanges are firmly in contact
will result in failure of the pedal frame Bolts.
HR3500 manual.indd 10
ASSEMBLY INSTRUCTIONS
1
2 Bolts are
pre-installed
20
12
12
19
12
2 bolts are pre-installed
12
3
20
12
19
1
20
19
20/09/2017 18:47