Rolling Code Programming - Kia 2018 Stinger Owner's Manual

Rolling code programming

Rolling code devices which are
"code-protected" and manufactured
after 1996 may be determined by the
following:
• Reference the device owner's
manual for verification.
• The handheld transmitter appears
to program the HomeLink
Universal Transceiver but does not
activate the device.
• Press and hold the
HomeLink ® button. The device has
the rolling code feature if the indi-
cator light flashes rapidly and then
turns solid after 2 seconds.
To train rolling code devices, follow
these instructions:
1.At the garage door opener receiver
(motor-head unit) in the garage,
locate the "learn" or "smart" button.
This can usually be found where
the hanging antenna wire is
attached to the motor-head unit.
Exact location and color of the but-
®
ton may vary by garage door open-
er brand.
If there is difficulty locating the
trained
training button, reference the
device owner's manual or please
visit our web site at www.home-
link.com.
2.Firmly press and release the
"learn" or "smart" button (which
activates the "training light").
✽ ✽ NOTICE
There are 30 seconds in which to ini-
tiate step 3.
Features of your vehicle
3.Return to the vehicle, firmly press
and hold for two seconds the
®
desired HomeLink button then
release. Repeat
"press/hold/release" sequence a
second time to complete the pro-
gramming. (Some devices may
require you to repeat this sequence
a third time to complete the pro-
gramming.)
4.Press and hold the just-trained
HomeLink ® button and observe the
red Status Indicator LED. If the indi-
cator light stays on constantly, pro-
gramming is complete and your
device should activate.
5.To program the remaining two
HomeLink ® buttons, follow either
steps 1 through 4 above for other
Rolling Code devices or steps 2
through 5 in Standard Programming
for standard devices.
the
4 61