Programming Homelink; Standard Programming - Kia 2018 Stinger Owner's Manual

Features of your vehicle

Programming HomeLink

✽ ✽ NOTICE
• When programming a garage
door opener, it is advised to park
the vehicle outside of the garage.
• It is recommended that a new bat-
tery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink
er training and accurate transaxle of
the radio-frequency signal.
• Some vehicles may require the igni-
tion switch to be turned to the sec-
ond position for programming
and/or operation of HomeLink
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps listed below,
®
HomeLink at: www.homelink.com
or 1-800-355-3515.
4 60
®

Standard programming

To train most devices, follow these
instructions:
1. For first-time programming, press
and hold the two outside buttons,
HomeLink
Channel 3 Buttons, until the indi-
cator light begins to flash (after 20
seconds). Release both buttons.
®
for quick-
Do not hold the buttons for longer
than 30 seconds.
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
®
.
while keeping the indicator light in
view.
3. Simultaneously press and hold
both the HomeLink
contact
held transmitter button. DO NOT
release the buttons until step 4
has been completed.
4. While continuing to hold the but-
tons the red Indicator Status LED
will flash slowly and then rapidly
after HomeLink
trains to the frequency signal from
the hand-held transmitter. Release
both buttons.
® Channel 1 and
® buttons
® and hand-
® successfully
5. Press and hold the just-trained
®
HomeLink button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate when
the HomeLink ® button is pressed
and released.
6. To program the remaining two
HomeLink ® buttons, follow steps 2
through 5.