Gate Operator & Canadian Programming; Operating Homelink; Reprogramming A Single Homelink Button - Kia 2018 Stinger Owner's Manual

Features of your vehicle
Gate operator & Canadian pro-
gramming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink
Control System button (note steps 2
through 4 in the
Programming portion of this docu-
ment) while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
4 62

Operating HomeLink

To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
® Wireless opener, gate operator, security sys-
tem, entry door lock, home/office
Standard lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
® Reprogramming a single
HomeLink
® button. To program a new device to a previ-
ously trained HomeLink
low these steps:
1. Press and hold the desired
HomeLink
release until step 4 has been com-
pleted.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter 1
to 3 inches away from the
HomeLink
3. Press and hold the handheld
transmitter button. The HomeLink
indicator light will flash, first slowly
and then rapidly.
4. When the indicator light begins to
flash rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
® button
® button, fol-
® button. Do NOT
® surface.
®
®
button and observe