Kia 2018 Stinger Owner's Manual page 210

Auto control (if equipped)
The rain sensor (A) located on the
upper end of the windshield glass
senses the amount of rainfall and
controls the wiping cycle for the
proper interval. The more it rains, the
faster the wiper operates. When the
rain stops, the wiper stops.
To vary the speed setting, turn the
speed control knob (1).
If the wiper switch is set in AUTO
mode when the ignition switch is ON,
the wiper will operate once to per-
form a self-check of the system. Set
the wiper to OFF (O) position when
the wiper is not in use.
CAUTION
When the ignition switch is ON
and the windshield wiper switch
is placed in the AUTO mode, use
OCK047458N
caution in the following situa-
tions to avoid any injury to the
hands or other parts of the body:
• Do not touch the upper end of
the windshield glass facing
the rain sensor.
• Do not wipe the upper end of
the windshield glass with a
damp or wet cloth.
• Do not put pressure on the
windshield glass.
Features of your vehicle
CAUTION
• When washing the vehicle, set
the wiper switch in the OFF
(O) position to stop the auto
wiper operation.
The wiper may operate and be
damaged if the switch is set in
the AUTO mode while washing
the vehicle.
• Do not remove the sensor
cover located on the upper
end of the passenger side
windshield glass. Damage to
system parts could occur and
may not be covered by your
vehicle warranty.
• When starting the vehicle in
winter, set the wiper switch in
the OFF (O) position.
Otherwise, wipers may oper-
ate and ice may damage the
windshield wiper
Always remove all snow and
ice and defrost the windshield
properly prior to operating the
windshield wipers.
(Continued)
blades.
4 123