Garmin G1000 Pilot's Manual page 77

AIRPORT FREQUENCY INFORMATION FIELD
The Airport Frequency Information Field displays radio
frequencies and frequency types for the selected airport, as
well as sector and altitude restrictions (where applicable).
If the selected airport has a localizer-based approach, the
localizer frequency is also listed on the Airport Frequency
Information Field. The Airport Frequency Information
Field may be used to quickly select and tune a COM or
NAV frequency.
To scroll through the frequency list and
tune to a desired frequency on the list:
1. Press the FMS knob to activate the cursor.
Turn the small or large FMS knob to scroll
2.
through the list, placing the cursor on the
desired frequency. If there are more frequen-
cies in the list than can be displayed on the
screen, a scroll bar along the right-hand side
of the screen indicates where you are within
the list.
Press the ENT key to place the selected fre-
3.
quency in the standby field of the 'COM' or
'NAV' window.
4. To remove the flashing cursor, press the FMS
knob.
Some listed frequencies may include designations for
limited usage, as follows:
• 'TX' – transmit only RX - receive only
• 'PT' – part time frequency
• 'i' – additional information exists, press the ENT
key
190-00381-03 Rev. A
If a listed frequency has sector or altitude restrictions,
the frequency is preceded by an info designation.
1.
2.
3.
Garmin G1000 MFD Pilot's Guide for the DA40
WAYPOINT PAGE GROUP
To view usage restrictions for a frequency:
Turn the small or large FMS knob to place the
cursor on the info designated frequency.
Press the ENT key to display the restriction
information.
To return to the Airport Frequency field, press
the ENT key.
Figure 8.8.4 Frequency Information Field
8-75