Error And Status Messages Appear On Smart Organizing Monitor - Ricoh BBP-PRSP213NW1 Manual

Error and Status Messages Appear on Smart
P
Organizing Monitor
Message
No Response from
I/O Device
Check the cable,
power cord, and
main switch.
Tray Not Detected or
No Paper
The indicated paper
source tray is not set
properly, or no
paper loaded.
Check the indicated
tray.
Tray 1 Jam
Bypass Tray Jam
Total Jam
Paper Size Mismatch
Paper of the selected
paper size is not
loaded in the
indicated paper
source tray.
Check the indicated
tray.
Paper Type
Mismatch
Paper of the selected
paper type is not
loaded in the
opal-p2_mf2_com_user_guide_00142158_eng.xml
Causes
• The power cable of the
machine is not plugged in.
• The power of the machine
is not turned ON.
• The USB cable is not
connected.
Tray 1 has run out of paper.
The bypass tray has run out of
paper.
A paper jam has occurred in the
machine.
The paper size specified on the
machine and the size specified
in the printer driver do not
match.
The paper type specified on the
machine and the type specified
in the printer driver do not
match.

Error and Status Messages Appear on Smart Organizing Monitor

Solutions
• Check the printer power cord.
• Check the printer power switch is on.
• Check the USB cable is properly
connected.
Load paper into Tray 1. See page 45
"Loading Paper".
Load paper into the bypass tray. See
page 45 "Loading Paper".
Remove the jammed paper. See page 210
"Paper Feed Problems".
For details about specifying the paper size
setting on the machine, see page 45
"Loading Paper". For details about
changing the paper size setting in the
printer driver, see the printer driver Help.
For details about changing the paper type
setting of the machine, see page 45
"Loading Paper". For details about
changing the paper type setting in the
printer driver, see the printer driver Help.
235
Draft 2014/01/07