Table of Contents
Advertisement
10. Troubleshooting
Message
Network is not Ready A scanned file could not be sent
On Hook or Stop key The machine has been off-hook
Out of Paper: X
Please Restart
Machine
Print Cart. Set Error
Remove Paper:
Bypass Tray
Replace Required
Soon:
Print Cartridge
Replacement
Required:
Print Cartridge
RX Comm. Error
Scan (NW)
Disconnected
230
Causes
because the machine has not
received IP address information
from the DHCP server
completely.
for an extended period of time.
The indicated tray has run out of
paper.
The machine needs to be
restarted.
The print cartridge has not been
installed or has not been
installed correctly.
The machine failed to proceed
with the print job, because tray
1 was specified as the input tray
but paper was set in the bypass
tray.
The print cartridge is almost
empty.
The machine has run out of
toner.
A reception error occurred, and
the fax could not be received
correctly.
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
Solutions
Wait until the machine receives the IP
address information completely, and then
try the operation again.
Put down the handset or press the [Clear/
Stop] key.
Load paper to the indicated tray. See
page 45 "Loading Paper".
Turn off the power, and then turn it back
on.
Reinstall the print cartridge. See page 203
"Replacing the Print Cartridge".
Remove paper from the bypass tray.
Prepare a new print cartridge.
Replace the print cartridge. See page 203
"Replacing the Print Cartridge".
If possible, contact the sender of the fax
and ask them to resend it.
Reconnect the Ethernet cable properly,
and then try the operation again.
opal-p2_mf2_com_user_guide_00142156_eng.xml
Draft 2014/01/07
Advertisement
Table of Contents
