Version Check Ignore - HP MSR Series Command Reference Manual

The following matrix shows the support of MSR routers for the command:
Hardware
MSR1000
MSR2000
MSR3000
MSR4000
Default
If software inconsistency is detected at startup, the standby MPU loads the current software images of the
active MPU.
Views
System view
Predefined user roles
network-admin
Usage guidelines
To ensure that the standby MPU always runs the same software images as the active MPU, configure both
the version auto-update enable command and the undo version check ignore command.
The startup software version check function examines the standby MPU's startup software images for
version inconsistency with the active MPU's current software images at startup. If their software versions
are different, the standby MPU copies the current software images of the active MPU, specifies them as
main startup software images, and reboots with these images.
To ensure a successful synchronization in a multi-user environment, make sure no one reboots or swaps
MPUs during the software synchronization process. You can configure the information center to output
the synchronization status to configuration terminals (see Network Management and Monitoring
Configuration Guide).
Examples
# Enable software auto-update for the standby MPU.
<Sysname> system-view
[Sysname] version auto-update enable
Related commands

version check ignore

version check ignore
Use version check ignore to disable startup software version check for the standby MPU at startup.
Use undo version check ignore to enable this function.
Syntax
version check ignore
undo version check ignore
The following matrix shows the support of MSR routers for the command:
Command compatibility
No
No
No
Yes
180